Introduction

Using the Beetle, various bus protocols can be read out directly on the web interface and in some cases also be written. In the device configuration of your Beetle, go to the Objects on the Network tab to access the bus protocols.

Use the dropdown at the top of the left sidebar to select the desired protocol. Depending on the protocol, you will then be offered further options with which you can read out and use the protocol.

The following protocols are supported:

• BACnet/IP

• Modbus

• M-Bus

• OPC UA

• TABS

• Modem

• I/O

In the following chapter, the Objects on the Network module is described in relation to BACnet/IP. The manner of use for other protocols is similar.

The icon next to the protocol name shows you the status of the corresponding service on the Beetle. To start or stop services, please switch to the Beetle website (see Beetle configuration).

Service running

Service stopped

Error